E1 over IP/VLAN
This module allows E1 leased line creation
- trough an Ethernet L3-IP network
- trough an Ethernet L2-VLAN network
The choice between the 2 modes is made by a simple mouse click trough the browser.
In IP mode, PSPE1 manage L3 layer conform to IPV4
In VLAN mode, PSPE1 manage L2 layer conform to 802.1Q and 802.1P
Case application : PBX E1 interconnection with VLAN line back-up
PSPE1 allows to maintain operationnal E1 equipments without any re-configuration
making easy migration to Ethernet technology and thus accelating ROI by
lowering operationnal expenses.
Network Interface :
Ethernet : 10
Base T, full duplex
network protocol : L3 IP, IPV4
: L2 VLAN, Tag 802.1P / 802.1Q
: Ethernet frame re-sequencing
: bandwidth optimization
Bandwidth optimization : ..
bandwidth real time fitted on E1 used channels.
Channels selection and booking allowed in order to always have the channel ON.
Link Back-up : (click
on image to zoom)
a/ In VPN-IP mode ...........
Using network protocols like OSPF or BGP
b/ In VPN-VLAN mode .......
Using Quadrillium back-up service based on link monitoring
E1 User Interface :
impedance : 120ohms / RJ45
Rate : 2,048Mbit/s ( +/- 50ppm)
Network transfer stability : 0,1 ppm
mode : frames & unframed
point to point : n x 64k
ITU compliance : G.703, G.821, G.823, G.704, G.732
PSPE1 equipments are managed by a web browser.
It is possible to manage the entire
link (local and remote equipments).
is made :
- local & remotely trough an "in-band" connection on Ethernet network link